Felt is a soft, flat material. It consists of disordered short fibers. They are pressed together with high vapor pressure. The fibers become so entangled in each other that the fabric does not fall apart again. Especially interesting about the felt is the missing thread. Damage to the structure does not lead to progressive fraying.

Cutting felt with a Laser Machine is, in comparison, much easier than with scissors or a cutter knife.

Cutting felt by hand is more difficult than it looks. Before manual cutting with scissors or a cutter knife, the contour must be recorded on the felt strip. When cutting scissors, the strip is guided by hand. The problem with this is that the contour can only be viewed over a short distance. When cutting with the cutter knife, the strip is placed on a hard surface. But when cutting, the fabric is constantly warped. This can affect the quality of the result lower. When laser cutting felt the strip lies loosely on a surface. The recorded contour is cut out by the felt laser as planned.

Synthetic fiber felt can be lasered better than natural felt. Please make sure that you do not process any synthetic fiber containing chlorine or chloride. Toxic fumes can be generated during this process. In our Knowledge base can you add anything to the Materials for laser read about.

The laser cutter has when cutting felt the following advantages:

- Speed

- Precision

- Repeat accuracy

- Better utilization of the material

- higher security.

Cutting the felt with the Mr Beam is a simple process. The contour is cut out of the lying material. It no longer warps during removal. Once laser parameters are set, you can use your Mr Beam start a serial production. With an exact planning you get a maximum of fittings out of a felt strip. The Mr Beam is completely safe. Especially when cutting felt this gives you the advantage that you can not hurt yourself.